Ford Edge
Courtesy Step Light Bulb Replacement Guide
How to change a burnt out courtesy step
or "puddle" light bulb in the side view mirror of a 2015 to 2019 Ford Edge.
2017 Edge Side View Mirror |
Puddle / Courtesy Step Light |
Push In Release Tab |
This automotive
maintenance tutorial was specifically written to assist owners of the second
generation 2015, 2016, 2017, 2018 and perhaps also the revised 2019, 2020,
2021 and 2022 model years of the Ford Edge SUV in changing a burnt out
courtesy step light or "puddle light" bulb in the bottom of the side view
mirror housings. Owners of other Ford and Lincoln vehicles such as the Escape, Expedition, EcoSport, Flex, Explorer, Fiesta, Focus, Fusion, Mustang, Taurus, Ranger, Transit Connect, F-150, Endura, C-Max, Kuga, Mondeo, MKZ, Navigator, Aviator, Nautilus and Continental may also find these DIY instructions to be helpful. The original OEM courtesy step / puddle light part number is Ford 3F1Z-13B375-AA. It is the same assembly for both the left (driver) and right (passenger) side view mirrors. If you would like to have brighter lights with much longer lasting bulbs, install some Ford LED Puddle Lights which are available from a variety of aftermarket manufacturers. The only tool needed to remove the old light assemblies is a small plastic pry bar tool or a flat head screwdriver. Move to the side of the vehicle with the burnt out light. |
||
|
||
Release Other Clip |
Remove Light Housing |
Light Housing Part Number |
Look at the light
housing on the under side of the side view mirror housing. Locate the two small black plastic tabs at the front and rear edges of the light housing. Gently push in the tabs with a plastic pry bar tool or a flat head screwdriver to release the retaining clips. Try to avoid using excessive force. The light housing should pop out relatively easily. Carefully remove the bulb housing from the underside of the side view mirror. |
||
Two Electrical Connectors |
Pull Off Power Plugs |
Part # 3F1Z-13B375-AA |
There are two spade
style electrical connectors attached to the light housing. Gently pull the spade connectors straight off the electrical terminals on the light housing. If you have trouble removing the connectors, gently wiggle the connector back and forth while pulling it straight off. The OEM (original equipment manufacturer) light bulb housing is part number Ford 3F1Z-13B375-AA. You can also replace them with brighter and longer lasting Ford LED Puddle Lights from a variety of aftermarket manufacturers. |
||
Push Spade Connectors |
Re-Insert Wires First |
Pop In New Assembly |
Push the spade
connectors on to the electrical terminals on the new light housing. Re-insert the wires into the opening in the underside of the side view mirror. Gently snap the new housing into place. You should hear and / or feel the two retaining clips "click" securely into place. To test the new courtesy step or "puddle light", turn on the parking lights or press the "Unlock" button on the key fob to re-activate the exterior lights. Be sure to record the bulb change in your vehicle's service records. Please check out all of my
2015-2019 Ford Edge DIY Repair & Maintenance Guides. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |