Toyota
4Runner Tail Light Bulbs Replacement Guide
How to replace the brake, rear turn
signal and reverse light bulbs in the tail light of a 2003-2009 Toyota 4Runner.
Toyota 4Runner Tail Light |
Open Cargo Liftgate |
Pry Out Access Panel |
This
automotive "how-to" guide was specifically written to assist owners
of the 4th generation (2003, 2004, 2005, 2006, 2007, 2008 & 2009) Toyota 4Runner SUV in replacing a burnt out
brake, rear turn signal or reverse light bulb in the tail light
assemblies. Owners of other related Toyota or Lexus vehicles such as the Hilux, Tacoma, Land Cruiser, T100, SW4, FJ Cruiser, Fortuner and Lexus GX may also find these DIY instructions to be helpful. Replacement tail light bulbs from Sylvania and other manufacturers including their part numbers are as follows: Brake # 7443, Rear Turn Signal # 7440A (992) and Reverse # 921. No tools are needed to replace any of the tail light bulbs in an 03-09 Toyota 4Runner SUV. |
||
|
||
Bulb Access Door Removed |
1/4 Turn Counter Clockwise |
Brake / Stop Light Bulb |
The first two steps
are to open the rear cargo liftgate and locate the small square tail light
bulb access panel.
You can pry out the panel with your fingernails or use a flathead screwdriver. The Brake Light bulb is located at the middle of the tail light assembly and is the only bulb socket connected by a wire harness. Remove the socket from the assembly by rotating it 1/4 turn counter clockwise before pulling it straight out. Pull the old # 7443 brake light bulb straight out from the socket and push in a new one. Insert the bulb into the tail light assembly and rotate the socket 1/4 turn clockwise to secure it in place. |
||
Old # 7443 Brake Bulb |
Brake Light In Middle |
Reverse Light Socket |
The Reverse
Light bulb is located at the bottom of the tail light assembly.
Remove it by rotating the socket 1/4 turn counter clockwise and pull it straight out of the tail light. Pull the old # 921 reverse light bulb straight out of the socket and push in a new one. If you would like to have brighter reverse lights, install some compatible 921 LED bulbs. Insert the bulb back into the tail light assembly and rotate the socket 1/4 turn clockwise to secure it in place. |
||
|
||
Pull Old Bulb Out |
7440A Turn Signal Bulb |
1/4 Turn Clockwise - Lock |
The Turn Signal
bulb is located at the top of the tail light assembly.
Rotate the socket 1/4 turn counter clockwise and pull it straight out. Pull the old # 7440A amber turn signal bulb straight out of the socket and push in a new one. Insert the new bulb into the tail light assembly and rotate the socket 1/4 turn clockwise to lock it in place. |
||
Testing Brake Light Bulb |
Test Turn Signal & Reverse |
Replace Bulb Access Panel |
Test the new tail
light bulbs by having someone step on the brake pedal, activate the hazard
signals and shift the transmission into reverse. For more, check out my
Toyota 4Runner Repair & Maintenance Guides page. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |
Privacy Policy About Paul & Author Contact Info