Owners of other General Motors vehicles such as the Spark, Cruze, Malibu, Sonic, Impala, Traverse, Tahoe, Trax, SS, GMC Terrain, Acadia, Yukon, Buick Verano, Regal, LaCrosse, Encore, Enclave and the Holden Barina may also find these DIY instructions to be helpful.

Replacement bulbs for the 2010, 2011, 2012 & 2013 Camaro models are as follows: Dual Low & High Beam Headlight # H13, and Front Turn Signal # 3457A.

Replacement bulbs for the 2014 & 2015 Camaro with their part numbers are as follows: Low Beam # H11, High Beam # H9 and Front Turn Signal # 7444NA (or 7444A).

No tools are needed to replace the bulbs on the passenger side.

To change the bulbs on the driver side, you will need a flathead screwdriver to disconnect the air box cover.

To change any of the bulbs in the driver side headlight assembly, you'll need to remove the top cover of the engine air filter box and pull out the plastic air intake tube.

Gently pull back the two release tabs on air box to release the top cover.

Then slide back the red plastic locking tab on the air intake temperature sensor's electrical connector.

Loosen the screw on the air intake hose clamp by turning it counterclockwise a few turns.

Pull the top half of the air box off and set it aside in a safe place.

Carefully disconnect the plastic air intake tube from the bottom half of the air box.

Now you can easily access the low beam, high beam and front turn signal light bulbs.

Reach in behind the headlight assembly and rotate the round black plastic dust cover 1/4 turn counterclockwise to remove it.

Set the dust cap aside in a safe place.

If you do get the new bulb dirty, wipe it off with a paper towel moistened with rubbing alcohol.

Insert a new # H11 low beam bulb in to the socket and rotate it 1/4 turn clockwise to secure it in place.

(The 2010, 2011, 2012 & 2013 Camaro models use a single Low & High Beam # H13 headlight bulb.)

Twist on the black plastic dust cap 1/4 turn in the clockwise direction.

The High Beam bulb is located near the center of the headlight housing.

Press the release tab on the electrical connector and slide it straight off the base of the old high beam bulb.

Rotate the old bulb 1/4 turn counterclockwise before pulling it straight out of the socket.

If you do get the new bulb dirty, wipe it off with a paper towel moistened with rubbing alcohol.

Insert a new # H9 high beam bulb in to the socket and rotate it 1/4 turn clockwise to secure it in place.

Replace the dust cap by rotating it 1/4 turn clockwise.

Rotate the base of the socket 1/4 turn counterclockwise before pulling it straight out of the assembly.

(The 2010, 2011, 2012 & 2013 Camaro models use a 3457A turn signal light bulb.)

Re-insert the turn signal light bulb socket in to the housing and rotate it 1/4 turn clockwise to lock it in place.

Re-insert the engine air filter.

Push the air intake temperature connector straight in to the socket.

Slide the red locking tab forward to secure it in place.

Test the new bulbs by turning on the headlights, activating the hazard signals and flashing the high beams.

For more, check out my other 2010-2015 GM Chevrolet Camaro DIY Repair Guides.