Ford Crown
Victoria Vanity Mirror Light Bulb Replacement Guide
How to replace a burnt out vanity mirror
light bulb in a 2nd generation 1998 to 2011 Ford Crown Victoria with pictures.
Passenger Vanity Mirror |
Pry Out Light Lens Cover |
Lens Cover Removed |
This
automotive "how-to" guide was specifically written to assist owners
of the second generation 1998-2011 Ford Crown Victoria in replacing
a burnt out vanity mirror light bulb. Owner's of other Ford, Lincoln or Mercury vehicles such as the Grand Marquis, Marauder, Town Car, Edge, Flex, Focus, Taurus, Fusion, Mustang, Fiesta, Five Hundred, Escape, Explorer, Probe, Expedition, Thunderbird, Escort, F-150, F-250 and F-350 may also find these DIY instructions to be helpful. A replacement vanity mirror light bulb for the Ford Crown Victoria is part number TS-14V1.5CP. Other compatible "festoon" or "fuse" type 29mm x 6mm light bulbs include the TS-14V1CP, # 6614F or the ACDelco 13502343.The only tool needed to replace the vanity mirror bulb is a small flathead screwdriver. Wear safety glasses if you have them. |
||
|
||
Vanity Mirror Light Bulb |
Gently Pry Out Bulb |
TS-14V1.5CP Bulb |
The first step is to flip open
the vanity mirror cover. Then locate the notch in the middle of the outer
edge of the vanity mirror light with the burnt out bulb. Insert the blade of the screwdriver into the notch and gently pry out the translucent lens cover. Pull out the old light bulb with your fingers or very carefully pry out the metal end of the bulb with the flathead screwdriver. Do not pry on the glass part of the bulb to prevent it from shattering and possibly causing eye injury. |
||
Vanity Mirror Bulb Socket |
Push In New Light Bulb |
|
The OEM vanity mirror light bulb is part # TS-14V1.5CP. It can also be replaced with any festoon or fuse style bulb that is 29mm x 6mm. Alternate compatible bulb part numbers include the TS-14V1CP (1 watt), the # 6614F or the Eiko 40842 - 6614F. The owner's manual lists the "Visor Vanity Lamp" as bulb # A6224PF. If you'd like to use a brighter LED bulb, purchase part # F30-WHP. Push the new bulb into the vanity mirror light socket. Avoid touching both of the metal contacts unless you disconnected the vehicle's battery. |
||
New Bulb Working |
Line Up Plastic Lens Cover |
|
Line up the translucent plastic lens cover over the vanity light and gently snap it into place. | ||
Push Lens Cover In Place |
Test Vanity Mirror Light |
|
The new vanity
mirror light bulb should have lit up immediately when you installed it. If
you disconnected the battery, re-connect it to test the new light bulb. For more,
check out my other
Ford Crown Victoria Repair & Maintenance Guides. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |
Privacy Policy About Paul & Author Contact Info