Chrysler 200
Map Light Bulbs Replacement Guide
How to change a burnt out overhead map
light bulb in a 2nd generation 2015, 2016 & 2017 Chrysler 200 sedan.
2015 Chrysler 200 Map Lights |
Insert Flathead Screwdriver |
Gently Pry Out Lens Cover |
This
automotive maintenance tutorial was specifically written to assist
owners of the second generation 2015, 2016 and 2017 Chrysler 200
sedan in changing a burnt out map light bulb in the overhead
console attached to the headliner. Owners of other Chrysler, Dodge, Jeep, RAM or Fiat vehicles such as the 300, Pacifica, Town & Country, Avenger, Charger, Challenger, Journey, Dart, Durango, Magnum, Grand Caravan, Fiat 500, Fiat 124 Spider, Grand Cherokee, Renegade, Wrangler, Compass, Liberty, Patriot, ProMaster, 1500 and C/V Tradesman minivan may also find these DIY instructions to be helpful. The compatible replacement miniature wedge base light bulb part number is 2825 (or W5W). There also brighter 2825 LED bulb options available. The only tool needed to access and change the map light bulbs is a small flathead screwdriver or a plastic pry bar tool. |
||
|
||
Lens Cover Removed |
Pull Out Old Light Bulb |
Old Light Bulb Removed |
To prevent from
scratching the plastic surfaces, I recommend either covering the tip of your
screwdriver with a thin micro fiber cloth or use a plastic pry bar tool. Insert the blade of your tool in between the front edge of the lens cover (near the windshield) and gently pry it out. You may need to re-insert the tool in to the outer edge of the lens cover and pry again to fully remove the lens cover. Try to avoid using excessive force. The lens cover should pop out relatively easily. Be careful when you remove the old light bulb. If it was recently turned on, it might still be hot enough to burn your fingers. Grasp the old light bulb with your thumb and forefinger before pulling it straight out of the socket. |
||
Push In New Light Bulb |
Press "On/Off" Switch |
Testing New Light Bulb |
|
||
Push a new
miniature wedge base bulb such as the
2825 (also known as the "W5W") straight in to the socket. If you would like to have brighter map lights, choose a compatible replacement LED bulb. Test the new light bulb by pressing the black plastic "On/Off" switch. |
||
Re-Insert Tabs - Front Edge |
Gently Pop In Rear Edge |
Map Light Bulbs Replaced |
Line up the lens
cover with the light housing on the overhead console. First, re-insert the two tabs on the rear edge of the lens cover (closest to the windshield). Then gently snap in the other side of the lens cover. Double check that both map lights work by pressing the "On/Off" switches. For more,
please check out all of my
2015-2017 Chrysler 200 DIY Repair & Maintenance Guides. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |
Privacy Policy About Paul & Author Contact Info