Paul's Travel Pictures

Jeep Wrangler Fog Light Bulbs Replacement Guide
How to replace the fog light bulbs in the front bumper of a 4th generation 2007 to 2011 "JK" Jeep Wrangler.

Main Menu                 Home                Digital Cameras                Misc. Pictures                 Articles                 My Blog

Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-001
Jeep Wrangler Fog Light
Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-002
Look Behind Front Bumper

This automotive "how-to" guide was specifically written to assist owners of the 4th generation "JK" 2007-2011 Jeep Wrangler in replacing a burnt out fog light bulb or installing aftermarket HID or LED fog lights.

Owners of previous generation Wrangler vehicles such as the YJ (1987-1995), TJ (1997-2006) or other Jeep vehicles such as the Compass, Patriot, Liberty and Grand Cherokee may also find these DIY instructions to be helpful.

Replacement bulbs for the fog or "driving lights" in a 2010-2011 are part number 2504 or "PSX24W" from Sylvania and other manufacturers such as ACDelco, Putco, Philips and AGTLED. The 2007-2009 Wrangler uses 9145 or H10 fog light bulbs.

No tools are needed to replace either of the fog light bulbs in the front bumper of a 07-11 Jeep Wrangler.

Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-003
Press Tab - Release Power
Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-004
Press In Both Sides
The fog light bulbs are easily accessed by sliding down underneath the vehicle and looking behind the bumper.

Press the release tab on the orange/red power connector and pull it straight off the rear of the bulb.

Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-005
Pull Out Old Bulb
Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-006
Old # 2504 Fog Light Bulb
Press firmly on the release tabs on the sides of the base of the old bulb and pull it straight out of the housing.



 

Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-007
Fog Light Bulb Housing
Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-008
Push In New # 2504 Bulb
Line up the new # 2504 fog light bulb (2010-2011 Wrangler) or # 9145 (H10) bulb (2007-2009 Wrangler) and push it straight into the housing until the fasteners click into place.
Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-009
Push On Power Connector
Jeep-Wrangler-Fog-Light-Bulbs-Replacement-Guide-010
Testing New Fog Light Bulb
Push the power connector straight onto the rear of the fog light bulb.

Test the new fog light bulb(s) by turning on the headlights and switching on the fog lights.

For more, check out my other Jeep Wrangler Repair & Maintenance Guides.
 

If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal.com "Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.)

Main Menu            Home            My Digital Cameras            Misc. Pictures            Articles            My Blog

 

Google

Copyright 2012 PaulsTravelPictures.com
 All Rights Reserved