Paul's Travel Pictures

Jeep Liberty Electrical Fuse Replacement Guide
How to replace a blown electrical fuse in a 2nd generation 2008-2012 Jeep Liberty with picture illustrated instructions.

Main Menu                 Home                Digital Cameras                Misc. Pictures                 Articles                 My Blog

Jeep-Liberty-Electrical-Fuse-Replacement-Guide-001
Jeep Liberty Fuse Box
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-002
Release Two Clips
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-003
Swing Open Cover

This automotive "how-to" guide was specifically written to assist owners of the 2nd generation 2008 to 2012 Jeep Liberty SUV in replacing a blown electrical fuse in the engine bay fuse block.

Owners of other Jeep, Dodge or Chrysler vehicles such as the Cherokee, Compass, Patriot, Wrangler, Grand Cherokee, Grand Caravan, Nitro, Dart, Avenger, Challenger, Durango, Journey, Charger, Town & Country, 300, and 200 may also find these DIY instructions to be helpful.

No additional tools are needed to replace any of the fuses in the engine bay fuse block.

A bright yellow fuse puller tool is included at the front driver side corner of the fuse block.

Jeep-Liberty-Electrical-Fuse-Replacement-Guide-004
Fuse Location Diagram
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-005
Yellow Fuse Puller Tool
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-006
Remove Fuse Puller Tool
The fuse block is located at the front driver side corner of the engine bay.

Press on the two tabs on the rear edge of the fuse block cover to release them. Swing open the fuse block cover and locate the bright yellow fuse puller tool. Pull the tool straight out of the fuse block.

Jeep-Liberty-Electrical-Fuse-Replacement-Guide-007
Pinch Tool & Grab Fuse
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-008
Hold Fuse Up To Light
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-009
Push Fuse Straight In



 

Pinch the larger end of the fuse puller tool to open the jaws and push them on to the fuse you'd like to inspect or replace.

Release some pressure on the end of the fuse puller tool and pull the fuse straight out of the block.

Inspect the fuse by holding it up to a light source. If the thin metal strip inside the fuse appears to be intact, the fuse is still good. If the metal strip appears to be broken, then the fuse is blown and needs to be replaced.

Even if the fuse appears to be intact, you should replace it as part of any electrical problem troubleshooting process since they are so inexpensive.

Jeep-Liberty-Electrical-Fuse-Replacement-Guide-010
Swing Cover Closed
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-011
Snap Fasteners In Place
Jeep-Liberty-Electrical-Fuse-Replacement-Guide-012
Fuse Block Cover Closed
Push the new fuse straight into the fuse block until it is fully seated inside the socket.

Re-insert the hinge on the fuse block cover down into the fuse block and swing the cover closed. Snap the two fasteners in place to secure the cover.

For more, check out my other Jeep Liberty Repair & Maintenance Guides.
 

If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal.com "Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.)

Main Menu            Home            My Digital Cameras            Misc. Pictures            Articles            My Blog

 

Google

Copyright 2013 PaulsTravelPictures.com
 All Rights Reserved