Hyundai
Tucson Dome Light Bulb Replacement Guide
How to change a burnt out overhead dome
light in a 2nd generation 2010-2015 Hyundai Tucson SUV with photos.
2014 Tucson Dome Light |
Insert Screwdriver In Notches |
Remove Lens Cover |
This
automotive maintenance tutorial was specifically written to assist
owners of the 2nd generation (2010, 2011, 2012, 2013, 2014 & 2015)
Hyundai Tucson SUV in changing a burnt out dome light bulb in the
headliner above the 2nd row of passenger seats. Owners of other Hyundai and Kia vehicles such as the Accent, Elantra, Sonata, Azera, Veloster, Tiburon, Genesis, Lavita, Veracruz, Santa Fe, ix35, Equus, Cadenza, Forte, Optima, Rio, Soul, Sedona, Sorento, Spectra and Sportage may also find these DIY instructions to be helpful. A replacement "festoon" or "fuse" style bulb is part number DE3175 (31mm in length).If you would like to have a brighter dome light, install a compatible DE3175 LED bulb. You may also be able to use the slightly longer # 6418 (35mm), 6423 (36mm) or 6411 (41mm) bulbs. The only tool needed to replace the bulb is a small flathead screwdriver or a plastic pry bar tool used to pry out the translucent plastic lens cover. |
||
|
||
Two Tabs On Front Edge |
Dome Light Bulb Exposed |
Pull Out Old Bulb |
To prevent from
scratching the plastic surfaces, you may choose to cover the tip of your
screwdriver with a thin micro fiber cloth. Insert the blade of the small flathead screwdriver in to one of the two small notches located on the rear edge of the translucent plastic lens cover. Gently pry out the lens cover. You may need to reposition the screwdriver in to the other notch and pry again. Set the lens cover aside in a safe place. If the old bulb was recently illuminated, be careful since it might still be hot enough to burn your skin. Grasp the old bulb with your thumb and forefinger before pulling it straight out of the socket. |
||
Old # DE3175 Bulb |
Empty Bulb Socket |
Push In New # DE3175 Bulb |
Push a new festoon
style # DE3175 bulb straight in to the socket. (Tip - If you installed an LED bulb but it isn't working, try flipping it around in the socket.) |
||
|
||
Test New Dome Light Bulb |
Line Up Lens Cover |
Re-Insert Plastic Tabs First |
Test the new dome
light bulb by pressing in the "On" button. Line up the lens cover with the dome light bulb housing. Insert the two plastic tabs on the front edge in first. |
||
Gently Snap In Rear Edge |
Lens Cover Replaced |
Testing New Dome Bulb |
Gently pop in the
rear edge of the lens cover. Test the new dome light bulb by pushing in the "On" button. For more,
check out my other
Hyundai Tucson DIY Repair & Maintenance Guides. |
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.) |
Copyright 2024 © PaulsTravelPictures.com
All Rights Reserved ®
Paul's Travel Pictures is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com. |
Privacy Policy About Paul & Author Contact Info