Paul's Travel Pictures

Hyundai Sonata 2.4L Engine Oil Change Guide
How to replace the motor oil and replace the filter on a 2011, 2012 & 2013 Hyundai Sonata with the 2.4L I4 engine.

Main Menu                 Home                Digital Cameras                Misc. Pictures                 Articles                 My Blog

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-001
2.4 Liter Theta II GDI I4
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-002
Oil Filler Cap SAE 5W-20
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-003
Remove Oil Filler Cap

This automotive "how-to" guide was specifically written to assist owners of the sixth generation (2011, 2012 & 2013) Hyundai Sonata in changing the motor oil and replacing the oil filter in the 2.4 liter Theta II GDI inline four cylinder engine.

Owners of other Hyundai or Kia vehicles equipped with the 2.4L Theta II engine such as the Tucson, Santa Fe, Optima, Rondo, Cadenza, Sportage, Sorento, and Forte may also find these DIY instructions to be helpful.

The items needed to complete this oil change include the following: a floor jack, jack stands, a 17mm socket with ratcheting wrench, a used oil catch container, an automotive funnel, a new oil filter and 5 quarts of SAE 5W-20 oil.

A few compatible oil filters include the following with their respective part numbers: Purolator L14459, Mobil1 M1-104, Bosch D3312, K&N HP-1004, Fram PH9688, ACDelco PF1127, Motorcraft FL810, and Driveworks DW-4459.

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-004
Raise Vehicle
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-005
Lower Engine Cover
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-006
Oil Filter Access Hole
The first few steps are to start the engine, allow it to warm up for a few minutes, and then shut if off. Warming up the engine helps suspend any contaminants within the old oil and also allows the old oil to drain out more quickly.

Next remove the black plastic oil filler cap on the top of the engine by twisting it counter clockwise. Removing the oil filler cap will prevent a vacuum from forming while draining out the old oil and also help it to drain out more quickly.

Then engage the parking brake and chock the rear wheels to prevent the vehicle from moving. Raise the front passenger side of the vehicle with the floor jack and securely support it with two jack stands. Alternatively, you could also raise the front of the vehicle with automotive ramps.

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-007
Open Access Door
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-008
Oil Drain Bolt Access Hole
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-009
Loosen 17mm Drain Bolt
Slide under the vehicle along with the used oil catch container, a 17mm socket and a ratcheting wrench.

Locate and remove the triangular shaped oil drain bolt access door near the rear of the engine which is marked with the words "Engine Oil".

Move the used oil catch container to below the drain bolt and remove it with the 17mm socket and ratcheting wrench.

Be careful when draining out the old oil as it may be hot enough to burn your skin depending on how long you warmed up the engine. If you get any of the used oil on your skin, wash it off as soon as possible since used motor oil is known to be carcinogenic (cancer causing).

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-010
Draining Old Oil
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-011
Replace Oil Drain Bolt
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-012
Tighten Oil Drain Bolt



 

Allow the old oil to drain out for at least a few minutes before re-inserting the oil drain bolt and tightening it with the 17mm socket and ratcheting wrench.

Tighten the oil drain bolt to just past hand tight or about 20-25 ft lbs of torque. Do not over tighten the oil drain bolt or you risk damaging the threads or the oil pan, which may cause an oil leak.

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-013
Replace Oil Drain Cover
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-014
Twist Off Old Oil Filter
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-015
Draining Oil From Filter
Double check that the oil drain bolt is snug and then snap the oil drain bolt access cover back into place on the black plastic engine underside cover.

Move the used oil catch container forwards to below the oil filter access hole and twist off the old oil filter by turning it counter clockwise. If you have trouble turning the old oil filter by hand, use an oil filter wrench or strap to help get it started.

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-016
Dip Finger In New Oil
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-017
Lubricate New Filter O-Ring
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-018
Twist On New Oil Filter
While the old oil is draining out of the oil filter receptacle, dip your pinky finger into some new 5W-20 oil and run it around the rubber o-ring on the new oil filter.

Lubricating the rubber o-ring on the new oil filter will allow it to form a better seal, prevent oil leaks, and also make it easier to remove the filter during the next oil change.

Twist the new oil filter on to the engine and tighten it to about 1/4 to 1/2 turn past hand tight. Do not use the oil filter wrench to tighten the new filter. Over tightening the new oil filter may damage the rubber o-ring and lead to oil leaks.

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-019
Insert Automotive Funnel
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-020
Pour In 4-4.5 Qts New Oil
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-021
Engine Oil Level Dipstick
Lower the car from the jack stands and the floor jack.

Insert the automotive funnel into the oil filler hole and carefully pour in about 4 to 4.5 quarts of the 2.4L I4 engine's 4.86 quart (4.6L) total engine oil capacity.

(2.0L Turbo Owners - The oil capacity for the Hyundai Sonata with the 2.0L Turbo GDI engine is the same 4.86 Qts.)

Replace the oil filler cap, run the engine for a few minutes, shut it off and let it rest for 5 to 10 minutes.

Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-022
Lower Vehicle From Jack
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-023
Check Oil Level - Fill To "F"
Hyundai-Sonata-Theta-II-I4-Engine-Oil-Change-Guide-024
Replace Oil Filler Cap
Check the engine oil level on the yellow handled dipstick and slowly add more oil into the oil filler hole while repeatedly checking the dipstick until the level reaches the "F" (full) mark indicated by the upper hole in the metal.

When the oil level is correct, re-insert the oil filler cap and tighten it by turning it clockwise.

Be sure to check the oil level on the dipstick several times over the next few days and watch your driveway for oil spots that may indicate a leak from the oil drain bolt or oil filter. Record the mileage and oil change details in your service record book.

For more, check out my other Hyundai Sonata Repair & Maintenance Guides page.
 

If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal.com "Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.)

Main Menu            Home            My Digital Cameras            Misc. Pictures            Articles            My Blog

 

Google

Copyright 2012 PaulsTravelPictures.com
 All Rights Reserved