Paul's Travel Pictures

Chevrolet Cobalt License Plate Light Bulb Replacement Guide
How to replace a burnt out license plate light bulb in a 2005 to 2010 GM Chevy Cobalt with picture illustrated steps.

Main Menu                 Home                Digital Cameras                Misc. Pictures                 Articles                 My Blog

License Plate Light
Remove 2 Phillips Screws
Pull Out Light Housing

This automotive "how-to" guide was specifically written to assist owners of the 2005 to 2010 Chevrolet Cobalt in replacing a burnt out license plate light bulb.

Owners of other similar GM vehicles such as the Cruze, Impala, Malibu, Sonic, Lumina, Buick LaCrosse, Regal, Verano, Enclave, GMC Acadia, Yukon, Pontiac Grand Prix, G6, G5, Grand Am, GTO, Vibe, Sunfire, Oldsmobile Alero, Aurora, and Cutlass may also find this DIY guide to be helpful.

A replacement license plate light bulb for the '05-'10 Cobalt is part # 194 from various manufacturers such as Sylvania, GE, PIAA and Eiko.

The only tool needed to replace the bulb is a standard Phillips head screwdriver.

1/4 Turn Counter Clockwise
Remove Bulb Socket
Old # 194 Light Bulb
Remove the two Phillips head screws that secure the license plate light bulb housing to the trunk lid by turning them counter clockwise.

Once the the two screws are removed, you can pull out the entire housing from the underside of the trunk lid. To access the bulb, rotate the light grey socket 1/4 turn counter clockwise and pull it straight out of the housing.

Light Bulb Socket
Push In New # 194 Bulb
Insert Bulb In Housing
Pull the old # 194 light bulb straight out of the socket and push in a new one. Insert the bulb back into the housing and rotate the socket 1/4 turn clockwise to secure it in place.


1/4 Turn Clockwise
Re-Install Bulb Housing
Insert 2 Phillips Screws
Then re-insert the bulb housing back into the trunk lid and thread in the two Phillips head screws a few turns by hand.
Tighten Two Screws
License Plate Bulb Installed
Testing New Bulb
Tighten the two screws with the Phillips head screwdriver to just past hand tight.

Test the new license plate light bulb by turning on the headlights.

For more, check out my other Chevy Cobalt Repair & Maintenance Guides.

If you found this guide to be helpful, please consider making a small donation by clicking on the "Donate" button located to the right of this paragraph. Thank you!
(Note: I am not a registered charity. Donations are not tax deductible.)

Main Menu            Home            My Digital Cameras            Misc. Pictures            Articles            My Blog



Copyright 2012
 All Rights Reserved